Fri May 06, 2005 3:45 pm
check out Little Kam's new ski-press frame
http://www.skibuilders.com/howto/equip/pneumatic.shtml
sexy in black.
Archive › Posts: 5
:: View topic - Ski Press Frame
Posts: 5 · 5 posts
Tue May 31, 2005 11:36 pm
Is 50 psi enough???
Wed Jun 01, 2005 9:22 pm
it works for me. i've pressed all of my skis at 50psi or lower (even one at 30psi) and have had no problems at all. vacumm presses, which a lot people use, only produce about 16psi - that's without using an autoclave.
Wed May 25, 2005 4:13 pm
how do you keep the core from shifting when running the router back and forth?
Wed May 25, 2005 5:15 pm
you can make your blank laminated core longer than the intended ski size and bolt the ends to your table. for example, if you're making a 180cm ski you can make a core that is about 200cm or so. bolt or screw the ends near the tips and tails to the table and router away. you'll just cut off the excess when you're done.
also, you may want to use some strong double-sided tape (double-sided duct tape works well) to help hold the core in place as well.
another method is to drill screws into your router table so that tips just peek out from the surface. the tips will grip your core and keep it from shifting around. here's a pic of what i mean:
which is described in more detail in the article section